TC40D cup holder

[jinman]

</font><font color="blue" class="small">( do you have a different draw pin for each attachment? )</font>

Naw! I just use them for rear ballast. /forums/images/graemlins/tongue.gif /forums/images/graemlins/laugh.gif

Okay, you caught me. /forums/images/graemlins/blush.gif I actually have a boxblade that uses three drawpins. The original ones it had didn't have pull-rings for removal, so I replaced them with new ones. I keep my implements about 200' from my barn, so I just tossed the old pins in there and then never removed them. Repeat this story for all the other "useless" paraphernalia and you see why I have an overloaded toolbox. /forums/images/graemlins/smile.gif

I do keep a busted screwdriver in the toolbox for removing busted shearpins. I use it to drive out the old pin by putting it in the hole and hitting it with with a Crescent Hammer. /forums/images/graemlins/shocked.gif /forums/images/graemlins/laugh.gif

 

[techinNY]

Cresent hammer, is that like a pry driver? It is amazing the ways we improvise to get the job done.