OP
Tractorganic
Silver Member
- Joined
- Nov 22, 2003
- Messages
- 125
- Tractor
- NH/TC40D SS; BCS 850, Brush Mower, Sulky, 'Tiller, Chipper, Snow Blower; JD X570-48-A
So, I had it done at the shop and it took 'em less than an hour and was under $50. They did feel a little bad about the clearance issue (chains hit sway bar and broke off a folding plate @ chain end) from their last "fix". I; however, can't figure the difference between what they did with the rims and dishing and just changing them to dished in and they couldn't explain what they did. But I now have 78" wheel base, not the 84.5" the manual cites for R4s dished in,and I can still slide onto my trailer very carefully:thumbsup:
What I can't do is tell anyone how it was done
. Sure hope they torqued the bolts!
Attached pixs of before and after. Hope you can make sense of 'em
Thanks,
Chris
What I can't do is tell anyone how it was done
. Sure hope they torqued the bolts!Attached pixs of before and after. Hope you can make sense of 'em
Thanks,
Chris
