chance60
New member
I would like to know if anybody knows what size hydraulic motor i would need to convert my three point auger to hydraulic drive.I would like to drive it with skidloader with 15gpm an 3000 psi
Three point auger conversion
- Thread starter chance60
- Start date
- Views: 2024
woodlandfarms
Super Member
- Joined
- Jul 31, 2006
- Messages
- 6,151
- Location
- Los Angeles / SW Washington
- Tractor
- PowerTrac 1850, Kubota RTV x900
woodlandfarms
Super Member
- Joined
- Jul 31, 2006
- Messages
- 6,151
- Location
- Los Angeles / SW Washington
- Tractor
- PowerTrac 1850, Kubota RTV x900
Or you can do what I did which was just buy a wheel motor and mount it onto my bits. Pictures are on the net and I can point you the way if interested.
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,973
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
15 GPM into the motor that woodlandfarms posted will turn the hyd motor at 361 rpm, and that is lower than the PTO speed of 540.
If your auger gear ratio is about 1.5 : 1 you can expect a speed of about 248 rpm.
It should work quite well, and you can reverse the auger if you get stuck.
If your auger gear ratio is about 1.5 : 1 you can expect a speed of about 248 rpm.
It should work quite well, and you can reverse the auger if you get stuck.
Here are some similar links:
