Three Point Lift Cylinder Needed

[toppop52]

I need a hydraulic lift cylinder for the 3 pt hitch on my 1855. Mine needs a rod as it was left out to corrode badly by the previous owner. It leaks so badly it's not practical to use. Rough dimensions are 11-12" pin to pin closed, 2" bore, 4-5" travel, has 1/2" x 20 threads on rod or can use one with yolk in place. Much harder to find than I expected.

 

[toppop52]

Corrected info; 10.25" pin to pin retracted, 4" travel, I'm willing to cut and weld but overall length has to be right and apparently nobody makes one that short anymore.

 

[DaButcher]

Most hydraulic repair shops can build any size rod, if all else fails.

 

[toppop52]

Most hydraulic repair shops can build any size rod, if all else fails.

I just hate to pay $200 for an $80 cylinder, but that may be the only option. Thanks for the help.:thumbsup: