Throttle Cable

[Frank Sorbello]

How hard is it to replace the throttle cable on a PT 422? And is there an aftermarket one vs Power Trac?

Thanks

Frank

 

[Frank Sorbello]

Looking to replace my throttle cable. Does anyone have a part number or size of the cable?

 

[sirmombo]

I replaced it on my 1430 in less than 45 minutes. It was sticking when the temperature dropped below 30, which was a big deal last winter in Wisconsin. I was worried about snaking it through tunnel from the front half to the back half, but it was very simple. There are access panels that are easily removed so I could push it straight through. The toughest part was straightening out the s bend at the engine end so I could attach it to the throttle lever on the engine. I was able to move the dash enough to get at the throttle bolts without disconnecting anything.

Bill

 

[MossRoad]

Frank,
I'd measure the throttle cable and then try here:
https://www.jackssmallengines.com/

 

[PTWannaHave]

I replaced it on my 1430 in less than 45 minutes. It was sticking when the temperature dropped below 30, which was a big deal last winter in Wisconsin. I was worried about snaking it through tunnel from the front half to the back half, but it was very simple. There are access panels that are easily removed so I could push it straight through. The toughest part was straightening out the s bend at the engine end so I could attach it to the throttle lever on the engine. I was able to move the dash enough to get at the throttle bolts without disconnecting anything.

Bill

Hi Bill,

Do you happen to know the length of that cable? (Maybe you didn't need to think about it if you ordered from PT.) Thank-you in advance.

My throttle cable 'died' today. Since it is attached at both ends, I presume the cable broke/separated inside the housing/sheathing. (I've never seen this on any machine...!!) It could very well be that, somewhere along the line, after ten years, the sheathing wore out from vibrations/rubbing, and the cable eventually also did so.

I'll find out when I pull it out, which I'll do when I have a replacement in my hands. If I'm not going to buy from PT, I need to know the length...

I'm happy to upgrade the quality, if that can be done.