N1ST
Silver Member
A couple of simple questions about my GC2310...
When checking tourque/tightening the tire bolts, should I lift the back tires off the ground with the stabalizers and the fronts off with the FEL?
The hoses on the back side of the FEL controler may be leaking a hair where they're thread on. How does one tighten these? There's the threaded piece with molded nut at the very end and then there's a nut right behind it. How tight should they be? Is there a rubber gasket involved - so not too tight?
Thanks.
When checking tourque/tightening the tire bolts, should I lift the back tires off the ground with the stabalizers and the fronts off with the FEL?
The hoses on the back side of the FEL controler may be leaking a hair where they're thread on. How does one tighten these? There's the threaded piece with molded nut at the very end and then there's a nut right behind it. How tight should they be? Is there a rubber gasket involved - so not too tight?
Thanks.
