TN75D how to adjust telescopic arm ends?

[Fguard]

Hi rookie question, one on the telescopic ends jiggled loose during transport and I can’t figure out how to slide it back in, can anyone help?

 

[i7win7]

Big ole hammer
when you release them to connect equipment, backing up and lifting 3pt the ends relatch

 

[Oscar1]

Hi rookie question, one on the telescopic ends jiggled loose during transport and I can’t figure out how to slide it back in, can anyone help?

Your missing parts of your link ends.

 

[Fguard]

View attachment 688296

Your missing parts of your link ends.

Thanks for that, so all I need to do is hammer the end back in?? spring doesn't need releasing?

Aah I see there should be a pin to lift the spring loaded section!

 

[Oscar1]

Yes there should be a pin with a ring attached to pull upward to extend arm ends. To retract with out any thing attached wiggle up and down and push in. Arm end will self lock.

 

[Fguard]

Cheers, I'll try wiggling in again with a gentle tap. So pins (that are missing!) shouldn't need to be lifted when retracting?

 

[i7win7]

Cheers, I'll try wiggling in again with a gentle tap. So pins (that are missing!) shouldn't need to be lifted when retracting?

backing up and lifting 3pt the ends will relatch. If the release rings/pins are missing, I'd disassemble that top cover and get repair parts ordered. May not need this lift arm feature if using quick hitch.