TODAYS SEAT TIME

Oldpath05 · Apr 1, 2020

Gordon Gould said:
I can't say it is best but for my pin on bucket it works great and it only weighs about 100 lbs. You could make one or a thumb. 30 hp L3010 - about the same as what you have.
View attachment 648635

gg

:thumbsup: If you think that would work on my size tractor I'll look into it, evidently it scoops up rocks. Everything Attachments must sell something like that thumb, looks like it just bolts on for the most part, nice group of pictures, I'll steel some of these to since I already took one of yours a while ago.

lostcreekranch · Apr 1, 2020

Oldpath05 said:
Now that's what I'm taking about, dont talk to me about hard working shiny tractors it sets off my PTSD. No rocks but least you have dust and mud, couldn't I ever help you out with your stressful rock shortage problem. Excellent pictures I'm ripping off the bottom one and adding it to my collection, might even transplant it and if I get enough of them I'll make a calendar to sell on ebay, should make millions........

OP, Use it as you wish but ... after you make your "millions" just send me a new 120 HP Tracked Skid Steer with A/C and a forestry mulcher head.

TractorGuy · Apr 3, 2020

Dug out an old sweetgum stump I've been dreading. Didn't take as long as I feared.

Gordon Gould · Apr 3, 2020

Pretty nice hoe ! Right tool for the job.

gg

buckeyefarmer · Apr 4, 2020

Couple years ago power line tree trimmers cut this and left it across my trail down to my creek. Decided to move it finally.

dragoneggs · Apr 4, 2020

I came close to maxing out my BX FEL lift while unloading my new 8in Jointer. Not sure of exact weight but north of 600lb.

amarsh64 · Apr 5, 2020

dragoneggs said:
I came close to maxing out my BX FEL lift while unloading my new 8in Jointer. Not sure of exact weight but north of 600lb.

View attachment 649231

Congrats on your new jointer . I am envious :thumbsup:

bazman82 · Apr 6, 2020

Finally took some pictures of my "small path in progress".

It may not look like it but there is 64 tons of stone down so far....they were some deep ruts to fill. I think another load of 32 tons of 3" crusher run will finish off this section and the next section I need to top off which is not pictured. Sure seems like a waste of money right now, but one day many moons from now someone will be glad I put this there...

Sawyer Rob · Apr 6, 2020

One of my "seat times" today was,

Here we go again!! IF you didn't store your PTO shaft apart, given enough time, you WILL have a stuck PTO shaft! But, I have a good cure for getting those stuck shafts apart,

This is the PROPER WAY to hook your chain on them,

I've never damaged a shaft pulling this way, and I've un-stuck some bad ones, that folks have dropped off! I've also seen guys damage U-joints NOT hooking this way!

SR