Toothbar Question

   / Toothbar Question #1  

Steve_Miller

Veteran Member
Joined
Mar 17, 2004
Messages
1,352
Location
Nova Scotia, Canada
Tractor
2006 Kioti CK30HST
Finally bought some teeth to build a toothbar. What angle should I put on the leading edge of the flat bar that the teeth are to be welded to? I was thinking around a thirty degree bevel. Would it be of any benefit to bevel the back edge as well?

Thanks in advance
Steve
 
   / Toothbar Question #2  
A bevel on the back edge may help the bucket dump slightly cleaner.
 
   / Toothbar Question #3  
Steve;
I just finished building my toothbar. I bought my base bar from Markham. It comes already beveled and it matched my Kubota FEL bucket edge angle perfectly. I think the angle is somewhere between 20 and 25 degrees. I also thought about beveling the back edge but after using the new toothbar in Georgia clay I noticed that there was very little or no clay sticking to the back edge of the toothbar. You can always try it out and bevel it later. Good luck.

SimS
 

Tractor & Equipment Auctions

Ingersoll Rand 185 Towable Diesel Air Compressor (A49461)
Ingersoll Rand 185...
2018 Toyota RAV4 Hybrid XLE AWD SUV (A50324)
2018 Toyota RAV4...
SET OF HANG ON WHEEL LOADER FORKS (A51242)
SET OF HANG ON...
2017 GENIE GTH-636 TELESCOPIC FORKLIFT (A51242)
2017 GENIE GTH-636...
2014 Gillig Transport Bus (A50323)
2014 Gillig...
100 GAL FUEL TANK (A50854)
100 GAL FUEL TANK...
 
Top