toplink cylinder

[navycut]

Thanks Twin.Do you know if little tractor has a web page.
RLP

 

[3RRL]

Thanks Twin.Do you know if little tractor has a web page.
RLP

A quick search popped this up
little tractor .com
I'd be interested in what their DPOCV are like and where they get them. Anybody know?
Thanks

 

[MadReferee]

I'll hazard a guess that they are left over inventory from when Integrated Engineering closed up shop.

 

[navycut]

I completed the rear remote and top link project.I used the swivel end cylinder from Surplus.I made some spacers out of 3/4 pipe to keep the cyl.centered.The end of the cyl will hit the tractor hitch if you don,t center it because the end of the swivel is so short.The top link works great.Now if I can figure out how to send photos I will take some pictures.

RL

 

[IslandTractor]

Navy,

Photos would be great. Especially if you can show the spacer you fabricated as well.

 

[TwinWillows]

3RRL - here's the only photo I have of the T&T setup from Little Tractor. Sorry but I don't know anythign about their supplier. I do know that I had to have them put RO's in both as they cycled way too fast w/o them.

 

[MadReferee]

The tilt cylinder looks exactly like the one I got from Integrated Engineering. It looks like they have some of the now defunct IE's leftover inventory.

 

[3RRL]

3RRL - here's the only photo I have of the T&T setup from Little Tractor. Sorry but I don't know anythign about their supplier. I do know that I had to have them put RO's in both as they cycled way too fast w/o them.

Thanks for posting the photo.
It looks to me the DPOCV are similar in size to the ones used by CCM. I wonder if they are from the same manufacturer? I sent them an email asking if they had any for sale. Hope to hear back from them and I'll let you know.

 

[dillo99]

I completed the rear remote and top link project.I used the swivel end cylinder from Surplus.I made some spacers out of 3/4 pipe to keep the cyl.centered.The end of the cyl will hit the tractor hitch if you don,t center it because the end of the swivel is so short.The top link works great.Now if I can figure out how to send photos I will take some pictures.

RL

I did the same thing Navycut....so far so good it is working well. I'll try to get some pictures for people.

 

[MadReferee]

Thanks for posting the photo.
It looks to me the DPOCV are similar in size to the ones used by CCM. I wonder if they are from the same manufacturer? I sent them an email asking if they had any for sale. Hope to hear back from them and I'll let you know.

Not even close. The IE valves are somewhat larger (taller) than the ones CCM was using (I have one of theirs too). They are a different manufacturer or at least a different style. The cylinder itself is different in that it has a screw on end so that they can be changed to fit different tractors.