Toro Outcross

[Nikkorott]

I was reading an earlier thread where someone was asking advice on buying a new mower. Curiosity got the better of me and I started looking online at some of the suggestions. I found this on the Toro website. Do any of you folks have any experience with these?

Outcross® 9060 | Toro

www.toro.com

 

[LS Tractor Owner]

That's got a high price ($55-65K), but the specs sound like it's quite a capable machine.

 

[jeff9366]

It looks very stable.

Puny appearing Three Point Hitch.

 

[Nikkorott]

It looks very stable.

Puny appearing Three Point Hitch.

I would have thought that about the 3 point hitch as well but the brochure has it rated as Cat 2.

 

[claggstractors]

Overall, that looks like a neat machine. 3PH specs are a little low but that would pick up anything you could power with ~60HP. Considering everything, $55k really isn't too bad of a price. Honestly, figured it be at least $70k.

 

[tomplum]

20 MPH reverse. Gotta have that! Depends on what sheet you look at.

 

[Citydude]

Isn't a 16K towing capacity a little high for that? I didn't see anywhere what it weighed.

 

[ruffdog]

It looks like the Toro version of the Bobcat Toolcat.

 

[ruffdog]

Cool things it has:
It has a remote so you can inch the vehicle F/R and move the 3pt while standing near it. It has a mechanical PTO vs the hydraulic one on the Toolcat. It weighs slightly more than my 5610 when it has the cab and loader arms. They both are AWS and hydraulically driven with about the same power and they both have traction control. I didn't see if it has high output hydraulics though.

 

[ruffdog]

Isn't a 16K towing capacity a little high for that? I didn't see anywhere what it weighed.

It looks like it weighs 6600 lbs with the cab and FEL.

 

[ruffdog]

The lower price may not include the cab or FEL.

https://www.mgcsa.org/resources/Sit...ith heat,but will entertain reasonable offers.

 

[ruffdog]

It looks very stable.

Puny appearing Three Point Hitch.

After watching some videos, the 3pt arms look short which makes you run a short pto shaft. At least the toolcat has a full size cat 1 3pt.