Torpedo/Salamander heater best practices?

[jrsavoie]

The Thermocouple went out on my 75,000 to 100,000 BTU propane Salamander/Torpedo heater

It has a junction block H06F thermocouple. I heard they also make a junction block that screws in where the thermocouple screws in and then you can use a regular, readily available thermocouple. Does anybody have a link to something like that?

Most of the H06F thermocouples I found online were not the correct thermocouple or they used a generic picture. - They did not have the junction block in the picture.

Does anybody have a recommendation for something to replace my 100,000 BTU propane torpedo?

I am looking for something propane & directional, that doesn't have to be right next to you - like a torpedo

The first torpedo heater I looked at was only $145 and was 125,000 max BTU

https://www.amazon.com/Mr-Heater-Forced-Propane-F271390/dp/B00KRFVG5G

 

[Jack Murdock]

There is a Ray Murray Inc warehouse in Flint Michigan that sells parts for LP White and other unit heaters ( Enerco etc. ) or if you post a picture I'll help you get a replacement

 

[jrsavoie]

There is a Ray Murray Inc warehouse in Flint Michigan that sells parts for LP White and other unit heaters ( Enerco etc. ) or if you post a picture I'll help you get a replacement

Thank you much. I will check them out and post up a picture when I get a chance