ts1610/Bolens G192 think I ran it out of fuel dont know how to prime

[purdum]

was ideling and slowly died. Put fuel in and acts like its trying to start but no go. Looked like some fuel was in the tank but was at an angle pushing fuel away from pickup.

 

[chrismac]

Do you have a filter bowl, start there, there are screws on the side or top of it, then the fuel pump, where the pipe connects, then at the injectors with someone cranking the engine over, ensure hand throttle is open,
Good luck.
Chris

 

[rich_ncal]

I had to get mine level before it would prime. With the right side down, fuel pump side down it did not prime.

Think there was also a screw for bleeding on the pump. But don’t have acres to the manual with that info until Friday.

 

[rich_ncal]

Search for old posts by me. There is a thread from Feb 2013 with some more information.

 

[purdum]

thanks i will check the bowl level it out tomorrow and get back to ya

 

[purdum]

Thanks rich I found your post

 

[purdum]

For future searchers that find themselves here. Link to Rich's post
Bleeding Air - TS1610 Diesel Lines - Believe it or Not