TS1910 Torque Specs

MightyMachine · Dec 2, 2004

Does anyone know the torque specs for the bolts at the back of the tractor which hold the drawbar bracket and are around the PTO?

JJPWAus · Dec 3, 2004

If your referring to the hitch plate that bolts directly onto the rear of the transmission, it's held on with both M12 bolts and M12 studs with nuts as far as I can make out.
The table in the service manual should two charts one for 4T bolts & nuts and another chart for 9T bolts and nuts & 7T nuts.
Tightening torque (4T) M12 is 434-520 lbs-in (9T) M12 is 781-954 lbs-in. I would assume that the bolts and stud/nuts for this plate are 4T as there is no notation against them in the parts manual, look like only the 9T are noted.
Hope this helps.

MightyMachine · Dec 3, 2004

Thanks greatly John. Would you happen to know the ft./lb. conversion for these torques? Both of my torque wrenches are in ft./lbs.
Thanks again.

JJPWAus · Dec 4, 2004

The Goggle calculator has the following conversion.
1 pounds inch = 0.0833333333 foot pounds
Which makes them 36.16-43.33 & 65.08-79.79 foot pounds respectively.
Does this sound about right??