turn signals..

[DaryleD]

Has anyone installed turn signals on their Rtv 900?
Does the kubota kit just plug in, or do wires have to be spliced?
Does anyone have any close up pictures that they could share?
Any custom mix and match pictures of what you've done, or seen, and taken a picture of would be fine. I'm trying to find the best looking solution, before I do anything to ours. I have to put them on before I can register it for the road. I can't find anything on the internet for pictures, or information. Thanks guys!
Daryle.

 

[dos_perros]

The Kubota 900 turn signal kit is complete. No need to splice wires. Instructions are good but need to be sure of proper hook-up to preexisting connectors. Routing wires to from aft to forward does not require pulling up floor mat. Takes a little time but you can do it.

 

[DaryleD]

The Kubota 900 turn signal kit is complete. No need to splice wires. Instructions are good but need to be sure of proper hook-up to preexisting connectors. Routing wires to from aft to forward does not require pulling up floor mat. Takes a little time but you can do it.

That's what I was hopeing for, with the Kubota kit. Would you happen to have any pictures of them, front and back, on an rtv? Thanks again.
Daryle.