jenkinsph
Super Star Member
I am looking for a good two spool or section valve to use on a boxblade for laser leveling. This would be a proportional control valve to use with Topcon electronics. I have finally received a quote for a Danfoss PVG 32 series valve built to order for $2,145 +shipping. Looking for ideas or opinions on the cost of this valve and any other suggestions.
Plan on using this valve to control raising and lowering of the boxblade and tilt control. Plan to put a receiver on each side of the boxblade and run this to the control box that powers the valves. While I will use it with my 4520 for now it can be used on a much larger tractor if needed in the future. Don't wan't to buy this stuff twice.
Plan on using this valve to control raising and lowering of the boxblade and tilt control. Plan to put a receiver on each side of the boxblade and run this to the control box that powers the valves. While I will use it with my 4520 for now it can be used on a much larger tractor if needed in the future. Don't wan't to buy this stuff twice.
