two stage clutch
- Thread starter bigarry1
- Start date
- Views: 2438
mark kram
New member
I want to know how to adjust a jenma 204. No luck so far.
Texasmark
Elite Member
- Joined
- Apr 24, 2012
- Messages
- 3,766
- Location
- N. Texas
- Tractor
- Ford: '88 3910 Series II, '80 3600, '65 3000; '07 6530C Branson with FEL, 2020 LS MT225S. Case-IH 395 and 895 with cab. All Diesels
Not familiar with your equip. Usually a single disc (no Live PTO) is adjusted so that the pedal has to be depressed roughly 2" (measured at the farthest end of the pedal) before you feel the resistance of the clutch springs.
If no spac (if you feel pressure immediately) you have the springs constantly depressed, how much is anyone's guess and with that the backing plate pressure is somewhat released and the disc can spin.
Otherwise, you may just have a worn out disc/weak pressure plate springs, and cannot adjust it any more to get the needed pressure to hold against a load. Time for a new disc and PP.
Mark
If no spac (if you feel pressure immediately) you have the springs constantly depressed, how much is anyone's guess and with that the backing plate pressure is somewhat released and the disc can spin.
Otherwise, you may just have a worn out disc/weak pressure plate springs, and cannot adjust it any more to get the needed pressure to hold against a load. Time for a new disc and PP.
Mark
Texasmark
Elite Member
- Joined
- Apr 24, 2012
- Messages
- 3,766
- Location
- N. Texas
- Tractor
- Ford: '88 3910 Series II, '80 3600, '65 3000; '07 6530C Branson with FEL, 2020 LS MT225S. Case-IH 395 and 895 with cab. All Diesels
I may have misread the title. I haven't done it but have read about it in serv. manuals. Have also been told that you take it to your dealer and let them set it up for you and you get it right the first time. I know Ford dealers do that. The money you spend is well worth only one trip into the innerds to get it right.
Mark
