U bolts for ROPS

   / U bolts for ROPS #1  

DDT

Platinum Member
Joined
Dec 18, 2000
Messages
953
Location
Clay Center, Kansas
Tractor
Kubota M6040/cab, BX25D, RTVX900
I want to strap my lights on the rops with 3" x 3" U Bolts. auto parts can only get them in 1/2" stud, I was thinking 1/4" or 5/16" would be heafty enough for a light. Any thoughts
 
   / U bolts for ROPS #2  
John Deere parts has "black" U-bolts to match the ROPS... about ~ $2.... maybe 5/16" ?

18-35197-JD5205JFMsignaturelogo.JPG
 
   / U bolts for ROPS #3  
Check your local Ace Hardware. I found the ones I needed there.

Hoss
 
   / U bolts for ROPS #4  
DDT, I've used large stainless steel worm gear clamps that are available in plumbing supplys. As you tighten them down with a littte tapping they conform to any shape and give a clean installation.
 
   / U bolts for ROPS
  • Thread Starter
#5  
Thanks for the help. I called my JD dealer and he did not know of any that size. Sounds like I can find some eles where.
 
   / U bolts for ROPS #6  
DDT, If you just want 1/4" u-bolts, they are easy to custom make. I have done it several times. Just take 1/4" threaded rod and bend it in a vise to the size you need. Then cut some 3/4" or 1" wide flat stock to the right length and drill a couple of holes to make the clamp. You can make them any size or shape you need. For installations where I do not want them to scratch or to absorb vibration, I cover the threaded rod with black rubber fuel line hose. That makes it look better too.

Andy
 

Tractor & Equipment Auctions

2015 Crane Carrier Co. Low Entry (LE2/LD2/LW2/LT2/ST2/SD2) Truck (A51692)
2015 Crane Carrier...
2018 INTERNATIONAL 4400 SBA 4X2 SERVICE TRUCK (A51406)
2018 INTERNATIONAL...
2014 Chevrolet Cruze Sedan (A50324)
2014 Chevrolet...
2014 Honda Accord Sedan (A50324)
2014 Honda Accord...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
2016 Ford F-150 4x4 Ext. Cab Pickup Truck (A51692)
2016 Ford F-150...
 
Top