Use of area in front between lift cylinders

[BobRip]

I like the tow hook and have seriously considered it. I actaully made a plate to weld there, but I don't have the courage to weld on the PT. However, maybe there is an even better thing to put there. I really like the two inch reciever, but I think it would be packed with dirt and be hard to clean out. Does anybody else have suggestions?

 

[MossRoad]

I like the tow hook and have seriously considered it. I actaully made a plate to weld there, but I don't have the courage to weld on the PT. However, maybe there is an even better thing to put there. I really like the two inch reciever, but I think it would be packed with dirt and be hard to clean out. Does anybody else have suggestions?

As I said, I don't like to get under a raised FEL for any reason, and if you have any implement on the front end, that makes it even more dangerous with the added weight and leverage it would have pulling down on you.

And yes, it would definately get packed with dirt and mowing debris. You'd have to keep a plug in it at all times when not in use, I would think, unless you made it open in the rear so a power washer could get in there and blow the debris through.