Utility box for 3p hitch

[JohnDeere4300]

johndeere4300, How did you do that?

Copy & paste.

Right click on the address bar & copy...THEN...right click to paste it.

You can paste it in the middle of a paragraph http://www.tractorbynet.com/forums/newreply.php?do=postreply&t=145784 like i did this.

When you get ready to paste, just have your cursor in the place where you want the link.

Hope that helps.

 

[JohnDeere4300]

I have a all purpose utility box on the front end instead of 3 pt rear end.

That's a nice utility box!

You should have a thread on that....If you have the pictures when you first started building it.

That would be handy around here....I really like it.

Thanks for sharing!

 

[Cottonhawk]

It's a simple design....
A 4'x6'x3' metal cage supported by the fork lift which slide into 1'x4' metal tube cross the bottom.
The gate opens towards the front flat with the floor so it become a 6'x7' working platform.
The box has short leg on each bottom corner so it can be left sitting on flat ground.
Here is another pic.....

 

[JohnDeere4300]

It's a simple design....
A 4'x6'x3' metal cage supported by the fork lift which slide into 1'x4' metal tube cross the bottom.
The gate opens towards the front flat with the floor so it become a 6'x7' working platform.
The box has short leg on each bottom corner so it can be left sitting on flat ground.
Here is another pic.....

That's a very good setup!

My wife would want to use that so she could pick apples, pears & cherries

Thanks for the picture!