I've been reading a bunch of threads trying to figure out this hydraulic stuff and have what I think is a simple question. I'm adding a set of rear remotes to my JD 3320 (for a CCM top link) which connects to existing ports on the tractor valve block. It includes hard lines to the back of the tractor and a control lever.
I'm curious if I can add a double selector valve to the quick connects on the rear remotes so I could divert the control to a tilt or perhaps to a grapple up front. I realize I wouldn't be able to use the top and tilt at the same time, but could tilt when needed than divert back to the top link. Is there any issue with this? A manual switch would probably be fine, but I do have room on my fender panel for a switch, so could use an electric one.
This:
https://www.surpluscenter.com/item.asp?UID=2009071018443340&item=9-5117-A&catname=hydraulic
or maybe this:
https://www.surpluscenter.com/item.asp?UID=2009073110535492&item=9-4128&catname=hydraulic
Is there a source for a smaller GPM valve (i.e. cheaper?)?
I'm curious if I can add a double selector valve to the quick connects on the rear remotes so I could divert the control to a tilt or perhaps to a grapple up front. I realize I wouldn't be able to use the top and tilt at the same time, but could tilt when needed than divert back to the top link. Is there any issue with this? A manual switch would probably be fine, but I do have room on my fender panel for a switch, so could use an electric one.
This:
https://www.surpluscenter.com/item.asp?UID=2009071018443340&item=9-5117-A&catname=hydraulic
or maybe this:
https://www.surpluscenter.com/item.asp?UID=2009073110535492&item=9-4128&catname=hydraulic
Is there a source for a smaller GPM valve (i.e. cheaper?)?