Oil & Fuel Was reading a thread about greasing the zerk fittings so I pulled out the grease gun

   / Was reading a thread about greasing the zerk fittings so I pulled out the grease gun #11  
And I assume you use "thin wall sockets"?

I was suggesting that sometimes 12pt sockets seem to have a thinner wall than 6pt sockets... Do your fittings really have a 10mm hex on them? That would be quite a bit larger than the norm...
 
   / Was reading a thread about greasing the zerk fittings so I pulled out the grease gun #12  
Do you have a "cleaner"? They work well.

imgres.jpg
 
   / Was reading a thread about greasing the zerk fittings so I pulled out the grease gun #13  
And I assume you use "thin wall sockets"?

LOL, I have a couple of sockets that met my grinder an got converted to "thin wall" status. (they were not my Snap On category ones but rather the Harbor Frt category)
 
   / Was reading a thread about greasing the zerk fittings so I pulled out the grease gun #14  
You do see shoulders on the fittings? Not the round press in ones are they?
 

Tractor & Equipment Auctions

2017 Bad Boy Outlaw XP 61in Zero Turn Mower (A48082)
2017 Bad Boy...
2015 FREIGHTLINER CA125SLP SLEEPER (A51219)
2015 FREIGHTLINER...
2015 LINDE H80D FORKLIFT (A50854)
2015 LINDE H80D...
2009 Freightliner Columbia 120  10-Speed, Mercedes MBE4000, 6x4 (A51039)
2009 Freightliner...
2015 Chevrolet Express Passenger Bus (A50323)
2015 Chevrolet...
Target Ecoline Walk behind concrete saw (A49461)
Target Ecoline...
 
Top