MikeD74T
Veteran Member
8561 said:
Do you still have their names? MikeD74T
well drilling / puunding
- Thread starter tommu56
- Start date
- Views: 16160
Do you still have their names? MikeD74T
8561
Platinum Member
- Joined
- Aug 1, 2003
- Messages
- 653
- Location
- New Hampshire
- Tractor
- Kubota B2410 Bi-Speed Turn, R4's, Top 'N' Tilt, LA 352 Loader w/ Toothbar
The guy in Henniker is Bill Gould. The one is Alton is Loring Carr. I can't think of the one in Concord. I would think if you contacted the Water Well Board, they might be able to provide a list of operators with cable machines.
Licensing Well Drillers, Well Design Code
Water Well Board
29 Hazen Dr.
Concord, NH 03301
271-3139
For what its worth, I've always believed pounding was the best method. NH DES has the following posted on their website when discussing the two methods:
"Some experts contend that the percussion process better fractures the rock in the immediate vicinity of the hole, and the bailing of water and pulverized particles keeps the rock fractures from becoming clogged with the drilling mud and rock cuttings. These two actions are believed to result in higher yields of those wells drilled by the percussion process. In recent years, drill bits for the rotary drilling machines have been redesigned to include a percussion action to better fracture the rock. Rotary drilling is normally less expensive and much less time consuming than percussion drilling. DES does not recommend any one method of construction over another."
More info can be found at: Bedrock (Artesian, Drilled) Well Design
Licensing Well Drillers, Well Design Code
Water Well Board
29 Hazen Dr.
Concord, NH 03301
271-3139
For what its worth, I've always believed pounding was the best method. NH DES has the following posted on their website when discussing the two methods:
"Some experts contend that the percussion process better fractures the rock in the immediate vicinity of the hole, and the bailing of water and pulverized particles keeps the rock fractures from becoming clogged with the drilling mud and rock cuttings. These two actions are believed to result in higher yields of those wells drilled by the percussion process. In recent years, drill bits for the rotary drilling machines have been redesigned to include a percussion action to better fracture the rock. Rotary drilling is normally less expensive and much less time consuming than percussion drilling. DES does not recommend any one method of construction over another."
More info can be found at: Bedrock (Artesian, Drilled) Well Design
