bill18163
Silver Member
I made this drawing so a friend of mine could machine two rear wheel adapters for my B2710. Ended up costing me right around $100 total. It took me a while using just my old drafting equipment. Bare bones, "T"square,compass,& triangle. The wheel adapters are on the tractor and everything fits,so I know the drawing is good. I went through of a lot of phone calls to finally get the number of a young engineer with Kubota on the west coast who verified some of the critical dimensions on the part. I am posting it here in case anyone else would like to use it.
Well I tried to attach the picture but it must be more than 100000 bytes. I can't post it. If you would like it, email me.
Well I tried to attach the picture but it must be more than 100000 bytes. I can't post it. If you would like it, email me.
