OP
pajoube
Veteran Member
- Joined
- Oct 11, 2001
- Messages
- 2,225
- Location
- Montana (Near Bozeman)
- Tractor
- Former Owner PowerTrac 425 (September 2003)
Your correct, the plateform goes into the forks.
Into the receiver would work just as well. I welded the square tubing tight on the forks so that I would not get much movement (1/4 inch on each side open).
PJ
Into the receiver would work just as well. I welded the square tubing tight on the forks so that I would not get much movement (1/4 inch on each side open).
PJ