Will Kubota 5240 third function hydraulics run a sander motor?

[art]

Yes you can run a constant use hydraulic motor on that system. Heat could be a problem but for the short amount of time you need to run it I feel you are safe. The tractor should give you over 8 gpm on the front. We sell a front hydraulic drive mower off the loader for trees and other uses called the Lane Shark and so far so good!

 

[Dave M7040]

I bought a hydraulic motor driven sickle bar cutter.
Attached to the bucket of my M7040 and run from a rear remote.
The issue I have had is the limited flow and pressure requirements for this hydraulic motor by Danfoss.
500 psi and 5 gpm

I tried controlling the motor speed manually but in the end I bought a pressure compensated flow control.
Winter arrived before I worked out the installation bugs.

Dave