Wiring in LED lights to my DK50

[KanakaRick]

The front two work lights have black and yellow wires going to them (no problem) but the back two have a Black, a Yellow and a White with a red stripe. What is the white and red stripe wire? Can I ignore it and wire up the rear LED lights without using the white with red stripe? I would assume so, but want confirmation.

Thanks

 

[JimR]

All you need s the power and a ground wire. I can't say which colors you need but I wired my LED's on my NX4510 from my rear lights also just by testing the wires. I also added in a mini rocker switch on the back fender for the LED's.

 

[countrybumpkin]

I answered in your other thread about the third wire, it's more than likely a backup wire, turns them on when placed in reverse. So no you don't have to use it. Just take a test light and check for the hot wire when the switch is on. I don't remember the wire colors it's been a few weeks sense I worked on a DK light system.