Work Light Wiring to Factory Harness

GoodGuy · Oct 8, 2004

Hello folks.....
I went to wire my "Non John Deere" Worklights to my JD4210 tonite & found that the factory harness connector is a new style connector (pic attached) & I don't have anything like it in my parts assortment. What are you guys doing here ??? Are you buying a proper harness connector & if so, where are you getting them or are you just snipping the connector off & doing your own wiring job with what connectors you have in the shop ?? Thanks
Eric

rockyridgefarm · Oct 9, 2004

S N I P .....

Nuru · Oct 10, 2004

Snip, solder, and implement a new connector. /forums/images/graemlins/laugh.gif

Bullzibart · Oct 11, 2004

I too am looking at putting some work lights on my JD4210 and don't know where to mount them. I would like to put two facing forward and two to the rear. Does anyone have any ideas on what kind and where to mount. I have to fold my ROPS to get the tractor to fit into the barn.

ronjhall · Oct 11, 2004

Here is a link to a thread with some pictures of how I mounted my lights.
Click Here

rockyridgefarm · Oct 11, 2004

I have mounted small halogens to the bottem side of the ROPS top. I used 3M trim tape, and they stuck like crazy. I routed the wires inside the ROPS, allowing slack for the hinge....