SLM1294
New member
I put a T & T system on my tractor (Kubota B2910) a while ago and wanted to show some pictures. I got the cylinders for CCM and made them fit with slight modifications. I used the rear hydraulic block from Kubota to feed the rear remote and used a 3 spool Prince "SV" stack valve. I fabricated a bracket to mount the valve to the ROPS. The closest lever would sometimes hit my shoulder so I replaced the handle with a round one and that solved the problem. I mounted two sets of QD bulkhead connectors to the rear of the tractor and fabricated a bracket for the third set. I also made a bracket to move the SMV sign a bit up and over to give more room for the hoses.
On the top cylinder I had to rotate the DPOCV and used right angles to streamline the assembly and prevent clearance problems as shown.
This setup has worked well and made many chores much easier.



On the top cylinder I had to rotate the DPOCV and used right angles to streamline the assembly and prevent clearance problems as shown.
This setup has worked well and made many chores much easier.


