The steering shaft on my Yanmar 155D needs to be replaced. Unfortunately a previous owner installed a steering box from a different tractor. A new Yanmar shaft is just over an inch too long. Now a steering shaft that is 16 3/8 inches long is needed. Can anyone identify a shaft that is 16 3/8 inch long?
YM155D steering shaft
- Thread starter N9175C
- Start date
- Views: 698
mddorange
Elite Member
- Joined
- Jul 16, 2014
- Messages
- 3,357
- Location
- Guin, AL
- Tractor
- 2014 Kubota L3200 DT w/LA524 FEL, Loaded rear tires, LP RCR 1860 5' Cutter, LP RTA 1258 5' Tiller, LP PFL 2042 Pallet Forks w/60" Extensions, KK BB60 Box Blade, KK PHD-12" Post Hole Digger
:welcome:
To the forum from Northwest Alabama. We have great members here and someone will probably have a good answer for you soon.
To the forum from Northwest Alabama. We have great members here and someone will probably have a good answer for you soon.
jimmysisson
Veteran Member
- Joined
- Jul 11, 2005
- Messages
- 2,358
- Location
- W.Mass
- Tractor
- 1993 NH 2120 (the best), 1974 MF 135 (sold, but solid), 1947 Farmall A (bought, sold, bought back, sold again), 1956 MH50 lbt (sold, in 1980, darn it)
If the ends are correct you could cut an inch out of the new shaft and weld it back together. Or cause that to be done, if no welder.
Jim
Jim
