YM226D Pwer Steering Unit

[DrewYM226D]

Hello, I am a new member but I've been reading posts for some time. My YM226D has a power steering unit and I know these were not standard. The valve has a small hole or crack. I'm not sure exactly since the guy I bought it from had some kind or gunky-goo over the spot to slow the leak. It looks like the valve is aluminum and it has "PH-5001" marked on the side. Does anyone know if this is a Yanmar or other after market unit? Anyone think it can be repaired? Thanks, I appreciate the help.

 

[kenmac]

can you post a picture of the area ?

 

[DrewYM226D]

I'm gonna try. I have to find my camera!

 

[BruceR]

Welcome Drew,

I think you'll find some pretty good parts support up in that area.

Bruce

 

[Ductape]

Perhaps the easiest way to repair it would be to run to the parts store and pick up some new gunky-goo? /forums/images/graemlins/tongue.gif

 

[Jagmandave]

Depending on where it is in the casting or what material it is , there are lots of ways to fix a problem. More info please........

 

[lens12]

I don't know if it is a Yanmar unit or not. A couple styles were used., but parts aren't available. A do have a complete Yanmar powersteering assembly . If it is disassembled it may be possible to have it welded.

 

[Gjamtrac]

I have repaired many of those PH units, there is two O-rings inside that need to be replaced. They are difficult to get to, but at least it is not expensive to do.

 

[Old_Style]

Len;
Will the power steering assembly you mentioned for the 226 fit the 1820D you sold me?
If so what is the cost of the unit uninstalled.
Tom Hosack

 

[DrewYM226D]

OK, here's a pic that shows the unit. The little piece at the top that shines is where the red gunky-goo is. I hope this picture helps. Thanks again. You guys are great!