Backhoe zerk fitting thread size
- Thread starter TJPhilips
- Start date
- Views: 14394
poncho62
Silver Member
This may help...
Zerk Fittings / Grease Fittings
The only 2 sizes I have ever used are.....
Grease Fittings / Zerk Fittings
AS Grease Fittings 1/4"-28 Taper Thread Fittings
1/8" PTF Grease Fittings 1/4" PTF Grease Fittings
1/2" NPT Grease Fittings Drive Type Grease Fittings
Zerk Fittings / Grease Fittings
The only 2 sizes I have ever used are.....
Grease Fittings / Zerk Fittings
AS Grease Fittings 1/4"-28 Taper Thread Fittings
1/8" PTF Grease Fittings 1/4" PTF Grease Fittings
1/2" NPT Grease Fittings Drive Type Grease Fittings
RNeumann
Elite Member
Tough to say. The loader is probably made in USA and the chassis isn't. The tie rods etc were probably sourced so who knows what they are. Some could even be press fit. I think you will need to take the offender to an auto parts store to match.
Or go this route and hope-
Swordfish 41030 SAE Grease Zerk Fitting Nipple Assortment, 110 Piece Amazon.com: Swordfish 41
SAE Grease Zerk Fitting Nipple Assortment, 11 Piece: AutomotiveSwordfish 41271 Metric Zerk Grease Fitting Assortment, 110 Piece Swordfish 41271 Metric Zerk Grease Fitting Assortment, 11 Piece - - Amazon.com
Tractor Seabee
Elite Member
- Joined
- Oct 5, 2011
- Messages
- 3,902
- Tractor
- Kubota BX25
I keep a box each of SAE and Metric assorted zerks from HF on hand at all times, saves running around for only one. NAPA has the kits also. The press fit ones are different problem, haven't found one on my BX or any implement yet.
Ron
Ron
Thanks for your input
Thanks for your advice
spursjingles
Bronze Member
Dont forget there are some push in zerks that look like treads but are not. I had no idea when a customer brought them in. Im used to tread on.
