Recent content by lzicc

I'm moving and need to sale my Kubota 2650HST with loader and backhoe. It has almost 400 hours on it. I am not sure what price I should ask. I bought it new. Any suggestions?

I need some ideas on protecting the back side of my bed along with the wheel wells. I have a bad mat which I like, but when I haul lumber and such, it hits the back of the bed or possibly wheel wells and I want to protect it from scratches. I don't want a spray or full liner. Any suggestions?

I have fireplace in my basement family. The family room is about 15' x 24' and is pretty open in the one corner where the split entry steps are. I want to install a ventless wall mount natural gas heater in there for supplemental heat. We only use the fireplace on the weekends since after work...

I want to mount extra lights on my B2650 for nighttime use when plowing snow. Since my garage door is only 7' tall, my ROPS is always folded. Where would be a good place to install lights for the front and rear with the ROPS folded that would me useful?

Here is how it is setup now. I installed the Rusco sediment filter. It is first in line from the well. This is more like a sediment/Spin down filter. From there it goes to the Big Blue, 20" 5 micron, then from there it goes to another big blue, 20" 1 micron then to the house faucets. I have had...

Here is a picture prior to installing the spin down. Looking at the picture, the incoming water comes up from the tank then goes left into the first big blue which is 5 micron, then the second BB which is a 1 micron. Then from there it goes to the water softener then out to the fixtures. The...

I moved into a house a few years ago that has a well. There was 1 Big Blue filter on the incoming water, then it leads to a water softener. I seem like I have to change the filter every couple of months once the water pressure goes down. It is a 1 micron filter. I put a second Big Blue filter...

This is after weeks using the erosion mat. I just removed it when I took this picture.

I have redone most of my yard landscape and am putting down new grass seed. I'm doing parts of it so I don't have to water everything all at once. I had screened topsoil brought in, 2 - 20 yard loads. What I do is I spread/rake the topsoil, spread the seed, lightly rake it again, roll it then...

I need to bury a wire in my yard. The run is about 100'. I don't want to make a mess of the yard\lawn. I looked at this video: Bury 1ft of wire 1in deep in 1 minutes without any mess. - YouTube and while this would work, I don't think it is as easy as it looks. I don't know what type of...

Here is another pull around today. We moved the split rails closer together this weekend and there are no turn around signs up also.

I am looking for a way to keep people from turning around in my driveway. This happens all the time. One person actually drove in my lawn to turn around and put ruts in my grass. I put signs up and also put a split rail corner on each side which didn't seem to help. I was going to put a gate up...

Since the topsoil will already be screened, I wonder if this drag harrow would work if I can get the topsoil down well with the fel.

I relandscaped my side and back yard and have it close to almost finished. I am waiting for september to plant grass seed. I will need to purchase at least 4 tandem truckloads of topsoil. I am going to get the screened topsoil and have mushroom mulch mixed in, like a 50/50 mix. What would be the...

These are my thoughts and I could be totally off. If it was bent, it would curl slow both ways. It only curls slow when I curl back. I tested the curl back under load and even though it is slow, it hasn't lost any strength or does it leak down, so that is why I am questioning the seals being...