Search results

I need a new radiator for my 79 YM2000BD. Other than the $285.00 new one, anybody have any luck getting one recored?

Here is a landscape rake I made in a few hours. I had a back blade that came with the tractor so I figured I could to use that frame for both the blade and the rake. (the green parts are all I had to make)

Cut a plate with the right bolt pattern and center hole diameter. Using the new plate as a pattern, cut the old center out of the wheel and weld in the new one. Grind/sand smooth. Sandblasted and ready for powdercoating. Powdercoated ready to insall. Now I just have to do the front...

I am rebuilding both front outer drive housings on my 2000BD. (FYI it cost ~$300 to replace all the bearings and seals) Both spindle housings are grooved from the knuckle seals. I would like to find a repair sleeve to cover the grooves. Do they make repair sleeves for the spindle housing...

Here is a drawbar hitch I made to move my trailer around. The reciever hitch is from a 1984-1996 Jeep Cherokee. They can be found at the you-pull-it junkyards for $10.00-$15.00. Any straight reciever hitch will work. Also check for 1994-1997 S10 Blazers as some of them use a straight reciever...

Anyone find a good source for steel hydraulic tubing? I need to make new hard lines for a FEL. Thanks.

Did Yanmar ever have a "factory" front end loader?

Did Yanmar ever offer a "factory" front end loader?

Does anyone know where to get blades and other parts for a Talor-Way Pittsburgh Model 222601 finish mower? The Taylor Pittsburgh website (www.taylorpittsburgh.com) is not working. Thanks

Anyone know where I can get a decompression cable for a 2000BD? Thanks