drs1023
Member
I just finished a complete rebuild of the engine in my 1961 MF35 - .010/.010 crank,
rebuilt rods, new clutches, oil pump rebuilt, carb kit, etc. Fired up on the
2nd turn of the engine, but ZERO oil pressure (new gauge and line). My service
manual didn't mention packing the pump with Vaseline or grease, but should should
I now drop the pan and do this task? I ran it less than 30 seconds, so damage will
be minimal. I removed the gauge and blew back into the tube - no oil in the tube
at all. Any suggestion will be appreciated.
Ron
rebuilt rods, new clutches, oil pump rebuilt, carb kit, etc. Fired up on the
2nd turn of the engine, but ZERO oil pressure (new gauge and line). My service
manual didn't mention packing the pump with Vaseline or grease, but should should
I now drop the pan and do this task? I ran it less than 30 seconds, so damage will
be minimal. I removed the gauge and blew back into the tube - no oil in the tube
at all. Any suggestion will be appreciated.
Ron