peterlindsay
New member
I have searched for informatiion on this in these threads but cannot find an answer so any help is appreciated. I have broken the top off one the valve controller? that the joystick fits into (joystick has three balls that go off the bottom of it and two go into seperate valve controllers? I think they are called - to controll the up down , dump, raise of the loader) JD has now started making them out of metal and not plastic so the replacement parts also need a kit to make it fit properly. So I was going to take just the joystick mech into the dealer and let them retro fit both of the parts because the one that is not broken will of course break if I do not. But I cannot get it off. There is a hex nut at the bottom of the unit that goes from the cables? to the control valve which I was told to remove - but all it seems to do is spin and loosen abit but does not release the unit, what am I doing wrong? Thanks