I bought this 1972 Ford 3400 tractor a few months ago. The tractor is an agricultural model painted yellow. The guy had pictures of it running, so I know it's been used somewhat recently. He said...
I purchased this 1971 Ford 3400 Utility Tractor a while back. It was started and drove onto the trailer. It has sat on the trailer for several months, then the other day I started it and drove it...
Can anyone here give me some advice on getting my Ford 3400 3cylinder diesel to start? The stopcock on the fuel line was turned off by the repair shop without my knowledge and I unknowingly drove...
Hey guys. I have a ford 3400. It's been sitting a while so I put new plugs wires, points, conditioner, button an carburetor an fuel filter. I got it running now when I put it in gear a let off the...
Hi, I picked up a 1963 Ford 3400. It had a couple of minor leaks in the steering column but functioned as it should. I decided to check the PS fluid level and top it off as needed. The manual said...
hello everyone,
Full disclosure: I am a total noob when it comes to machines but I do have a logical mind therefore I am hoping that I can resolve this issue with your input.
I bought a ford...
Does my loader have the float option? Is it something I can add if it doesn't.
The boom lift valve looks much longer than the bucket trip valve but when I press all the way forward, the lever...
I have a 1975 Ford 3400 with the wonderful Holley Carb. I have been struggling with it lately. When im going down a hill or the load lightens on the tractor, the engine revs. I throttle down...
I have a 1973 Ford 3400 with a loader. I use it for all around house hold chores. My front tires are passenger car tires. They are rubbing on the spindles and one has worn to the point it is...
Helping a friend of a friend with a no start Ford 3400 gas. Turns over if jump direct from the battery to the S terminal on the solenoid so I guessing it the ignition switch. Does anybody know if...
I'm going to exchange the fluid in my 3400s loader. I would like to get as much fluid out as possible because I have water in the hydraulic fluid. Any tips or tricks to get the most fluid out...
I bought recently bought a Ford 3400 The previous owner replaced the starter and solenoid. I changed all the fluids and did all the maintenance. I went to use it to move some rocks the other day...
I have been working on my new to me ford 3400. I'm going through all the maintenance and fixing anything that needs it. Today I found that the govener arm is falling off the carb. I pulled the...
I just purchased a new tractor for my house. After a lot of research and budgeting I settled on a Ford 3400 Gas with a 730 loader. I found a 1965 gas job that looks like it has very very low...
I bought a Ford 3400 Industrial Tractor last year. I love it, its just the right size and power that I need. More often than not, it runs perfectly. I've run my bush-hog for 6 hours straight...
Been having ongoing problems with the 3pt. Worked for a while after i changed the filters and fluids in the rear sump however power to the 3pt remained intermittent. Then the 3pt stopped...
Been having ongoing problems with the 3pt. Worked for a while after i changed the filters and fluids in the rear sump however power to the 3pt remained intermittent. Then the 3pt stopped...
Been having ongoing problems with the 3pt. Worked for a while after i changed the filters and fluids in the rear sump however power to the 3pt remained intermittent. Then the 3pt stopped...
What do you guys this of this Ford 3400? Looks like a solid unit but wondering if its priced to high. I know its 4x2 which isnt the best for loader work but with the backhoe on the back and...
I bought it last weekend and I'm still trying to figure things out. Anyway, it is a 1974 3400 with loader. Today I learned that it has a dual clutch setup to support the 540 pto. I think the trans...
I have a 1969 Ford 3400 with 730 loader. The hydraulic pump and oil take a very long time, up to an hour, to warm up when it is 15 degrees F and colder. The pump will whine, chatter and move...
I have a Ford 3400 TLB, and would like to know the weight of the hoe itself.
From Tractordata.com I get a weight for the bare tractor of 3723 lbs.
They also give a weight of 1431 lbs. for the...
My father-in-law has a 3400 Industrial needing a shifting fork. Part Number C5NN731J. It's the 4th-6th gear fork. Any suggestions on where to search? I've googled as long as I can before my eyes...
Hi everyone,
new at tractors, but trying to figure out what the difference in an industrial tractor and a regular agriculture tractors. Found a 1973 Ford 3400 with loader and backhoe for 7500...
Hi all
I bought a 1970 ford 3400 from a guy moving out of state anyhow he said the tractor had been sitting for a couple of years so i got it home flushed the tank.The lines to the filters all...
Ford 3400 & 4400 diesel generator voltage output at battery. NOT battery's voltage!
I'm having trouble getting a good voltage output when checking with a meter at battery terminals. Have...
I have a 3400 and rebuilt the carb. It has a Holley. Now it is smoking and sounds like it is running on 2 cylinders. According to the paper I got with the carb if the carb float has a spring on it...
Is there anybody out there that can give a rookie some tips on where to start to repair what appears to be a stripped front hydraulic pump shaft. Was using my 72 Ford 3400 the other day and it...
Looking to sell My Ford 3400. Not exactly sure on the year. I am going to guess in the later years.
720 Front End Loader
3 cyl gas 49hp (which is More than the diesel was @ 46hp)
4400hrs
4 speed...
I was blading our road when the tractor started sputtering and then died. Thinking it had simply run out of gas like it has before, I got some gas and poured in the tank. I cannot get it to...
Just aquired a ford 3400 w/ front end loader. all systems work great except the steering. It is as if the hydraulics are not working to assist the steering.
The Fluid reservoir is full.
Any...
I have two ford 3400s one works fine. The other is a diesel with a serious hydrolic problem. Every time the bucket is pulled all the way in on the front end loader, a seal on the pump blows and...
Hi guy's I bought a 3400 taractor in April and the guy told me that the draft control was acting up for the 3 point lift. What it is if i dont have it set to stay all the way up it drifts. But if...
Hey guys.. I have a Ford 3400 with a 730 loader. When I first got it, the lift and bucket cylinders leaked down fast due to multiple external leaks (lines, cylinder caps, etc). I have...
Ford 3400 tractor loader problem
--------------------------------------------------------------------------------
My loader moves slower than I thing it should. I had bubbles in the fluid after...
Hi everyone, I posted this in the ford part of the forums a few days ago and just noticed this section for hydraulics (new here) so I thought I would put it here as well, as the issue is not...
Hi, I've used the forum for information a lot before, but just registered and this is my first time posting. Lots of great information shared here and I appreciate all the info I've gotten.
I...
Pray I changed the oil and filter in the transmission and the oil was a light grey in colour. The vent to the transmission was open and able to breath. My question is where did all the moisture...
I just bought a ford 3400 tractor 4 speed with loader. I think the rpm is 540. I am going to an auction soon with different used mowers at it, and I was wondering how do I tell which ones are 540...
Hi, I have a 1968 Ford 3400 in good working condition with a front end loader, new tires all the way around, new rims on the back wheels, wheel weights, hydraulic connections in the back. I would...
No idea on the year , but it has sat for a few years, poured some gas down the intake and she fired up. needs some serious wiring help though and pulled the carb for rebuild.
How I found it..
Hey guys, I found an older ford 3400 with loader. It has 2300hrs and was supposedly running fine yesterday but the guy said it seems to not be getting fuel now. I can probably pick it up for...
I have a Ford 3400 taht has quit running, used it half a day yesterday, cranked it this morning and it ran about 10 seconds and it quit, will not start back up, I changed the fuel filter day...
Trble starting my Ford 3400, if think it is the ignition switch, I could turn it off aand on and eventtually it would start, it finally quit doing that, no clicking no nothin, trying to get the sw...
Can anyone advise me about what appears to be a wire descending from ignition switch to a plug (sensor) directly below the ignition switch in the transmission casing.I assume it is a sensor for...
Just got a used Ford 3400. Has new points cause they were burnt. Runs for about an hour just fine. Then, under a load, it stalls. I think it would sit there and idol all day but when I tried...
While pulling a 2 bottom plow for about an hour the tractor acts likes its not getting any fuel, runs rough, then quits. Happened twice, restarts after cooling off, cleaned fuel filter, didnt...
Hi Guys,
I recently purchased my first tractor, a 1969 Ford 3400. Got it for $4400 with loader, brush hog, and weight box.
Picture is about 6 weeks old so all that snow is gone, thank...
I have a ford 3400 that the hydraulic pump cracked on the bottom back when it was cold. So I thought It might have had some water in it and frozen and cracked. I had it welded and it has ran for...
Hello All...New to this forum and new to working on old tractors. Here's by problem, I just had my 3400 diesel engine rebuilt got it put back together and running sunday night but I have a few...
I just started to use my new (to me) ford 3400 , when running hyd. fluid starts seeping out from pump, looks like a gasket behind 6 bolts. Can i simply remove the 6 bolts and replace gasket? or is...
Well this is my first tractor a Ford 3400. I bought the tractor 3 weeks ago at a great deal. I knew it may have needed some work. When I got the tractor home I began cutting the field for about 4...
Hey guys, I just bought a Ford 3400 at a good price. Everything about the tractor is nice and sound except when I started pushing is a bit. All of a sudden power steering fluid started pouring out...
Hello,
Sorry to post this in two spots but this section seems to get more action.
I have a Ford 3400 and the 3 point hitch is acting up. The hitch will only go all the way up or all the way...
Hello,
I have a Ford 3400 and the 3 point hitch is acting up. The hitch will only go all the way up or all the way down, you can't get it to do anything in between even if you only move the lever...
Ok, been lurking around since my last post on my tractor aqusition<sp>.
Since it's cooled off some here, I've had more time to go through the beast.
After repairing one leak in the power steering...
Hi Guys! Found a 67(?) Ford 3400 w/FEL. gasser, PTO, 3pt, medium tires, 2 remotes, power steering - runs good. The guy wants $4000 for it, but might trade straight across for my
IH 460 w/FEL...