Robert_in_NY
Super Member
- Joined
- Aug 1, 2001
- Messages
- 8,552
- Location
- Silver Creek, NY
- Tractor
- Case-IH Farmall 45A, Kubota M8540 Narrow, New Holland TN 65, Bobcat 331, Ford 1920, 1952 John Deere M, Allis Chalmers B, Bombardier Traxter XT, Massey Harris 81RC and a John Deere 3300 combine, Cub Cadet GT1554
Well, here in New York if you cause an accident while on the road you are liable. Ways you will be liable for causing an accident would be running down the shoulder of the road but still being on the road a bit forcing cars to cross the center line. Turning into the lane of an oncoming car, not having an SMV or proper lighting...basically, if you operate on the road you need to either be completely in the lane or completely on the shoulder. There is no inbetween. If you are in the lane completely and someone passes you and causes an accident they are liable because they were in the wrong lane.
If you do plan on roading your tractor and you are too wide for the shoulder stay in your lane until you have a safe spot to pull over without damaging your equipment or anyones property. If you try to ride the shoulder people will cross the center line and force the oncoming cars onto the other shoulder. When I first started roading equipment a lot I tried to be nice and stay over to the side as much as possible. I had more people get run off onto the shoulder and I was almost hit quite a few times as cars cut back into the lane because of oncoming cars. However, when I started staying in the lane people had to slow down and pass me when it was safe. I still get that one extra vehicle who just has to pass and will force an oncoming car onto the shoulder but nothing near as bad as when I skirted the shoulder being "nice".
I learned that you can not rely on other drivers being smart when you are out there with a tractor. You actually have to chaperone them and allow them to pass when it is safe so if there is a lot of traffic then you pull over when it is safe for them and you. If it isn't safe for you then they will have to drive slow for a few extra minute.
Hopefully I made that clear, if you are properly in your lane you are safe for the most part. If you are partially in the lane you are going to be liable for any accidents caused by other cars (well, at least in New York)
If you do plan on roading your tractor and you are too wide for the shoulder stay in your lane until you have a safe spot to pull over without damaging your equipment or anyones property. If you try to ride the shoulder people will cross the center line and force the oncoming cars onto the other shoulder. When I first started roading equipment a lot I tried to be nice and stay over to the side as much as possible. I had more people get run off onto the shoulder and I was almost hit quite a few times as cars cut back into the lane because of oncoming cars. However, when I started staying in the lane people had to slow down and pass me when it was safe. I still get that one extra vehicle who just has to pass and will force an oncoming car onto the shoulder but nothing near as bad as when I skirted the shoulder being "nice".
I learned that you can not rely on other drivers being smart when you are out there with a tractor. You actually have to chaperone them and allow them to pass when it is safe so if there is a lot of traffic then you pull over when it is safe for them and you. If it isn't safe for you then they will have to drive slow for a few extra minute.
Hopefully I made that clear, if you are properly in your lane you are safe for the most part. If you are partially in the lane you are going to be liable for any accidents caused by other cars (well, at least in New York)