removing lever ends

[pedalstomper78]

It looks like I have to pull apart the rear end of my Case DX33 (think of it as a red TC33DA.). To get the fenders off.....how do the balls on the ends of the selector levers (rear and mid PTO, 3point and hydraulic remote controls, etc) off? I see no fasteners on them and it doesn't look like they can be pulled off without breaking them. Any help woukd be greatly appreciated!!!!

 

[pedalstomper78]

Please help!!!! LOL

 

[rayikeo2]

I don't know but have you tried to unscrew them? I am just guessing as I haven't seen them.

 

[pedalstomper78]

Unfortunately.....it's flat stock that goes into the knob. Rotation will = expensive lol

 

[mjcountrybumpkin]

Take lever of under panel. Knobs are more than likely press fit, which means one time use

 

[mjcountrybumpkin]

Take lever off under panel. Knobs are more than likely press fit, which means one time use

Edited

 

[wrenchguy]

Carefully heat them with a heat gun or hairdryer if necessary. Use light pulling pressure,should come off without causing damage so that reuse is possible. Heat them up as well for instasllation.

 

[powerpace]

If they dont screw off. Use a box end wrench the same size as the shaft. Place the wrench around the shaft under the ball and tap upward. Works for me and tap it back on afterward.

 

[pedalstomper78]

Used thewrench method and it worked great! Thx

 

[powerpace]

Used thewrench method and it worked great! Thx

Your welcome. I've done that numerous times over the years.