tractorshopper
Veteran Member
Update. I didn't get this done yesterday. I did go at it again today to completion. Had problems with loader mainly due to my tooth bar getting in way. Used BB to peel layers one pass at a time. When full I lifted it drove forward and then pushed it while turning Until off the road edge. Then I'd line back up and start again. Once I started getting close to gravel and sometimes a little into it, it started to melt and slush up. This is when I used the loader. Curled bucket up and used rear edge in float mode to really clean it up. Next time snow like this is forecasted I will get some lumber and try to build a plow board to push snow with fel. Thanks for the input. Was fun seat time for sure. And as an added bonus, my tractor is much cleaner now , especially the fel and bb.