mrmikey
Veteran Member
Frozen at one time maybe, if so hopefully no other damage?.....Mike
quicksandfarmer
Elite Member
Freezing I would believe.
zonta223
Platinum Member
- Joined
- Aug 26, 2009
- Messages
- 507
- Location
- Adelaide South Australia
- Tractor
- Foton FT404, International 444 with forklift, International B250, Kubota L2000DT, Truck converted to all terrain forklift and lots of other junk
Don't actually know in OZ he is but would not be many places here were it would get cold enough to freeze water/coolant in an engine. Would be interested to know if that was the problem
Hi,
Thanks for your thoughts. Freezing not an issue where we are. Near the coast - heat more an issue. Regularly high 90's or hotter in summer.
I've replaced the head gasket but having an issue with a fuel injector. It didn't seat properly and I discovered when I pulled it out and felt down in the hole that I'd missed a copper washer. Seems there were two on the injector body but I had only removed one. When I re fitted it I obviously bent the washer that had remained in, making the injector not seat properly.
So when I started it up I had exhaust gases escaping out around the injector and a very noisy motor!
So getting some new washers this week.
Surprised there were two washers. Anyone know if this is correct? Jinma 204 TY290 2 cylinder engine.
Thanks
Mark
Thanks for your thoughts. Freezing not an issue where we are. Near the coast - heat more an issue. Regularly high 90's or hotter in summer.
I've replaced the head gasket but having an issue with a fuel injector. It didn't seat properly and I discovered when I pulled it out and felt down in the hole that I'd missed a copper washer. Seems there were two on the injector body but I had only removed one. When I re fitted it I obviously bent the washer that had remained in, making the injector not seat properly.
So when I started it up I had exhaust gases escaping out around the injector and a very noisy motor!
So getting some new washers this week.
Surprised there were two washers. Anyone know if this is correct? Jinma 204 TY290 2 cylinder engine.
Thanks
Mark