Used NH 630 round baler

[buckeyefarmer]

The seller's son said less then 1000 bales on it. The father said less than 3000.

 

[Tx Jim]

CV shaft is the biggest bill on them. Blew it on ours, was going to be $1000 for a new one. Don't have a CV joint anymore.

Since deleting CV joint on your baler have you ever watched the chains & belts while turning with pto engaged? I tried operating my JD rd baler with CV deleted and the chains/belts flopped way too much in a hard turn to my liking so I bought a new CV tractor 1/2 of shaft. Do you realize that the baler end of the driveshaft & baler shafts speed up/slow down in a hard turn when no CV joint is utilized? I suppose if one baled in straight lines & turned pto off in sharp turns there would be no problem but I bale the old fashioned way round & round.

 

[Farmer495]

Since deleting CV joint on your baler have you ever watched the chains & belts while turning with pto engaged? I tried operating my JD rd baler with CV deleted and the chains/belts flopped way too much in a hard turn to my liking so I bought a new CV tractor 1/2 of shaft. Do you realize that the baler end of the driveshaft & baler shafts speed up/slow down in a hard turn when no CV joint is utilized? I suppose if one baled in straight lines & turned pto off in sharp turns there would be no problem but I bale the old fashioned way round & round.

No issues other than it can not turn as sharp. Bale back and forth here, 2 round and round windrows to open field up and then take every 3rd windrow so no sharp turns end of field.

Been running it that way for several years now. No other piece of equipment here has a CV joint. Will agree CV joint much nicer to run.

 

[kthompson]

buckeyefarmer, this link shows you can download manual for that baler for free. I KNOW NOthing about them. Seems odd assortment of manuals they have. NC itself may offer it.

If you don't mind my asking you are in Maryland and your handle is buckeyefarmer, guess you are from Ohio?

 

[buckeyefarmer]

What link?

Yep, grew up on a farm in ohio. My dad still has cattle and I go help when I can.

Just listed on uship to see if I can get someone to haul it to ohio for me.

 

[kthompson]

What link?

Yep, grew up on a farm in ohio. My dad still has cattle and I go help when I can.

Just listed on uship to see if I can get someone to haul it to ohio for me.

Not too good on my part on the link, too me about 15 minutes to find it: http://www.pdfsmanualshere.com/new-holland-630-baler-manual.pdf

I found about four sites showing they had the manual for download and on each one my malware show possible malware.

 

[buckeyefarmer]

Thanks.
Got one bid to haul, and it expires tomorrow. Not sure I want to jump on it that quick.

 

[buckeyefarmer]

Anybody use uship? Got a couple bids so far. I figured people would bid up to the date you specify. My bids want an immediate response.

One guy just dropped his bid. He wanted to take it tomorrow, and I'm not available to load till afternoon.

 

[buckeyefarmer]

Cancelled my uship ad. Seems they want to play games with one day bids and changing prices.

 

[Farmer495]

Never used it, but yesterdaystractors has a hauling board to line up equipment shipments.