Good morning!!!!

[Ed of all trades]

Wow, everyone sure has a lot going on. Got the meeting done and UPS delivered my new table saw. Dewalt portable, weighs about 40 lb and would easy fit in the car. Ordered it from Amazon Thursday and also ordered two Craig skill saw guides from Home Depot, they are still processing my order. Not really important to me but if I had something I had to do and was waiting for it....... Been a nice lazy day.

PJ, Are you SURE you like your job? Sounds like you need a new job or a good insurance.

Have a great day. Ed

 

[rswyan]

48F and partly cloudy @ 17:30.

Just finished sweeping the chimney up here at the shop. Was 55F when I got up here ... but it was pretty sunny today, 70F now inside.

Didn't seem all that dirty to me but sure seems to draw a lot better. Most of what I swept out has been sent back through and burned.

The job wasn't without a little bit of drama ... I had the brush and three sections of rod up the chimney and was pulling it back and went to take a rod off and got distracted and failed to grab the rod I was trying to unscrew from and took two off instead of one. Oops ...

Made a tool out of an old pegboard hook and managed to fish the last rod with the brush attached down to where I could reach it and pull it out.

SMH ...

 

[toppop52]

I’m fighting the USPS, eBay and non responsive seller, I ordered a garage door opener to replace the one that shorted out and caught fire. Ordered on October 23, shipped on 10-25, last scanned in Jacksonville on the 28, after that it just says en route to destination. $149.95 in seller’s pocket.

 

[Buppies]

Ron December the 12th or so very cold for you very cold

Farmer December 14th pretty cold for you

Randy I saw that too two scenarios at play forms off east coast Va capes so Maryland northern Va gets hammered or low forms over Texas which we might all have some fun

 

[buckeyefarmer]

Hope you guys are wrong on the weather predicting.. Lol

I'm having surgery tomorrow, so keep me in your prayers. Hopefully not a big deal, but you never know.

My neighbor returned my phd sunday while i was gone, put it back on my stand. I noticed he fixed it. Yrs ago, One of the cutting blades had gotten stuck on a rock, and bent down when i pulled it up. Since i hardly used it, i left it like that, and it still dug the occasional hole ok. It's great having a good neighbor.

 

[Steppenwolfe]

For those interested in the weather our current western trough east ridge looks to break down around the 10th of December or so with a pretty good storm afterwards. SE look for rain mid Atlantic rain coast snow ice interior NE probably good dose of snow. Will have to wait and see if this change occurs

Was at the cabin in Meadows of Dan today.... Gorgeous weather, almost warm. Can't last too much longer. Trying to get a few more projects done.

 

[lostcreekranch]

Hope you guys are wrong on the weather predicting.. Lol

I'm having surgery tomorrow, so keep me in your prayers. Hopefully not a big deal, but you never know.

My neighbor returned my phd sunday while i was gone, put it back on my stand. I noticed he fixed it. Yrs ago, One of the cutting blades had gotten stuck on a rock, and bent down when i pulled it up. Since i hardly used it, i left it like that, and it still dug the occasional hole ok. It's great having a good neighbor.

You’re lucky Buckeye.

One of my “neighbors” told me he was looking into buying a rear finish mower. I told him that he could borrow mine for a couple of days to see how it worked for him.

He returned it two weeks later, when I wasn’t home one day. When I started to hook it back up, to my tractor, I noticed one of the rear wheels was lopsided. Upon closer inspection both bearings on that wheel were completely wiped out with only one of the bearing cages still even present, on shaft, it was destroyed. These are dual shielded 6340ZZ bearings.

When I asked him about it, he said it was fine when he returned it?

Note to self .......... another lesson learned.

 

[Buppies]

Prayers sent Buckeyefarmer

 

[daugen]

Buckeye, best wishes for an easy tomorrow.
General anesthesia always makes one wonder...
If you are staying overnight, tell them you were approved for lobster.

did more chipping today, ran errands, seemed to get tired not doing much of anything.
Small combine next door picking the last of the soy beans on a dusty dry day.
I'll be back watering things tomorrow. For once I had hoped we would go into a rainy season
but it's been dry here for awhile. Which reminds me I need to walk back to the pond and take pictures.
When the water level is down it's very cool to see all the cyprus knees/root knobs. Still looking for that chest of Spanish
doubloons in there...

 

[Buppies]

You’re lucky Buckeye.

One of my “neighbors” told me he was looking into buying a rear finish mower. I told him that he could borrow mine for a couple of days to see how it worked for him.

He returned it two weeks later, when I wasn’t home one day. When I started to hook it back up, to my tractor, I noticed one of the rear wheels was lopsided. Upon closer inspection both bearings on that wheel were completely wiped out with only one of the bearing cages still even present, on shaft, it was destroyed. These are dual shielded 6340ZZ bearings.

When I asked him about it, he said it was fine when he returned it?

Note to self .......... another lesson learned.

Rick some people just don't care sorry that happened to you