leaking kingpin seal

[not2old]

Is anyone able to direct me as to where I can find instructions on how to replace a kingpin seal on a 2010 GC2610? No luck on google, but I always seem to use the wrong terms.

Thanks

 

[irvingj]

A pic would help -- are you referring to the front axle "final case" seal (where the wheel turns for steering)?

 

[cdaigle430]

For correct part name try...(use guest account)


AGCO Parts Books

 

[mwayne]

Here's a video of a Branson tractor being repaired:

4x4 Branson 2400 Tractor - Front Spindle Seals - YouTube

 

[not2old]

A pic would help -- are you referring to the front axle "final case" seal (where the wheel turns for steering)?

View attachment 585792

Yes, the seal at the centre of this picture. And thanks to others for their help too.

 

[irvingj]

Thanks for the link, mwayne! Really great video. I haven't yet had to change those seals on my 2310, but good to know how to do it; I'm sure I'll need to change them eventually.

My M-F service manual is really poor in that regard -- even shows, in fig. 20, removing the seal, but not til fig. 21 does it indicate removing the snap ring to separate the final case!

 

[mwayne]

Thanks for the link, mwayne! Really great video. I haven't yet had to change those seals on my 2310, but good to know how to do it; I'm sure I'll need to change them eventually.

My M-F service manual is really poor in that regard -- even shows, in fig. 20, removing the seal, but not til fig. 21 does it indicate removing the snap ring to separate the final case!

You're welcome, that guy is a good mechanic and did a good job with the video.

 

[Devi8]

I did one of mine on my 2610 in September, I used this description https://www.tractorbynet.com/forums/massey-ferguson-owning-operating/121406-front-axle-seals-gc-2310-a.html

Hardest part was separating the out to inner portal (they are silicone together), and make sure you have a set of 90 degree snap ring pliers otherwise a pretty easy job.

 

[boutym]

Older thread but figured I'd contribute. I'm about to tackle this myself. 300 hours on the tractor and the right side is leaking like crazy. Left looks like it's been seeping. I'm capable of the fix but out of curiosity I called the dealer for a quote to get an idea of the difficulty and was told 8 hours for both sides. I don't know if I buy 8 hours. It looks like a fairly simple operation.

 

[irvingj]

Please post how you did it & such (with pics, please!)... Mine are still OK, but I figure it's only a matter of time. Now have about 950 hrs on my 2310; seals still look the same as in pic above --- some dust stuck there, indicative of a very slight weep.