gregfender
Gold Member
Now I just need to get it dirty.
New L2501 is here
- Thread starter gregfender
- Start date
- Views: 4649
-
- Tags
- kubota l2501
Carl_NH
Elite Member
- Joined
- Apr 5, 2002
- Messages
- 3,778
- Location
- Coastal NH
- Tractor
- 01 Kubota B21TLB, 2010 Ferris 52" ZTR, Cub Cadet 1811, Gravely Super8
congrats on your very Nice new orange machine!
Paystar
Elite Member
Did you get rear remotes? I was curious how they are set up on those as far as the control levers. Do they have the extra slots in fender for them?
LS Tractor Owner
Super Member
- Joined
- May 1, 2017
- Messages
- 7,562
- Location
- Edgewood, NM
- Tractor
- LS XG3025 TLB, Previously MT125 TLB, Craftsman GTS6500
Nice tractor and congratulations! Looks like you are set up to do some work!
BRMyers
Platinum Member
Very nice! Congrats on the new tractor.
OP
gregfender
Gold Member
No rear remotes. But I will probably get them later. I am assuming they would have to be fender mounted.
Thomas
Epic Contributor
- Joined
- Apr 6, 2000
- Messages
- 31,031
- Location
- Lebanon,NH.
- Tractor
- Kubota B2650HSD w/Frontloader & CC LTX1046 & Craftman T2200 lawn mower.
Now that's what I call starting the new year off right :thumbsup: congrats.
old and tired
Veteran Member
Not if you get the factory kit, which is expensive but a very clean install. It goes into the slot next to the 3 point lift handle.
I mounted a 3 spool valve above the FEL controls. One for the grapple, one for the hydraulic top link and one for the hydraulic side link. I just prefer it in front of me.
Some have mounted it below the FEL controls... personal preference.
Paystar
Elite Member
OK thanks for info. Can you get one or two factory installed rear remotes on these?