Thinking about parting out older Branson 4520 with loader or sell complete

[mhen711]

I have a older Branson (maybe a 2002) 4520 that has seen better days. Thinking about parting it out or just taking to tractor auction. It has a Yanmar 4 cylinder 4tne88. Cant get fuel out of injection pump but turns over freely. Wiring has corrosion and has various hydraulic leaks. Never heard it run.

 

[K5lwq]

I recommend getting it running. I doubt much is wrong but hard to say.

 

[pmsmechanic]

I have two engines here like that. I can't get any fuel out of the injection pumps. Too many years sitting out in the sun without running and the fuel has hardened inside the pump.

 

[mhen711]

I think that's what happened to mine too. Been sitting around too long just like yours.

 

[K5lwq]

Where are you located and what do you want for it?

 

[ericm979]

How hard is it to clean out an injection pump?

 

[ptsg]

Also, some injection pumps will have a screen right at the pump fuel inlet. Not sure if that's the case with that particular one though but it's just a thought.

Had to clean the screen once of the VE pump on a Mitsubishi Pajero/Montero I had.

 

[pmsmechanic]

How hard is it to clean out an injection pump?

$!200 - $1500 hard.

 

[FastEddieR]

Where are you located and what do you want for it?

This!

 

[mhen711]

$3000

 

[K5lwq]

I would be a player if everything else is good. Of course it depends on where you are located but even if it is out of my reach someone else might take it off your hands.

 

[mhen711]

Located just across the Oklahoma line at Lake Texoma.

 

[K5lwq]

I will send you a PM later this afternoon. If anyone else wants this tractor say so now... :thumbsup:

 

[K5lwq]

PM sent

 

[CEN3035]

If you end up parting the tractor out, I would be interested in some parts from it.

 

[mhen711]

OK, I will.

 

[K5lwq]

Just what I needed, another project. :laughing:

We shall see if we can get this dude rolling again. :thumbsup:

 

[pmsmechanic]

Just what I needed, another project. :laughing:

We shall see if we can get this dude rolling again. :thumbsup:

Well either continue in this thread if the op is ok with that or start a new one and let us know how it goes. If you start a new thread please post a link here so we can follow. Thanks

 

[K5lwq]

It will be a few weeks but I will start a new thread. I have to complete a couple of things before I can get this into my shop.

 

[ptsg]

Nice! Can't wait to see K5 work some of his magic on this bad boy!