Number15
Gold Member
- Joined
- Feb 20, 2021
- Messages
- 358
- Location
- Rhea County TN
- Tractor
- AC 7600 TTR, Branson 5520CH, Grasshopper 928D2
Why these over a nice torque wrench? Just curious
Swollen Ford Lug nuts
- Thread starter gsganzer
- Start date
- Views: 18807
Bill Guenthner
Platinum Member
They allow you to use your impact driver with no danger of over torquing. No strong arm work for this old man. I’m not going to hand torque 32 lug nuts.
Number15
Gold Member
- Joined
- Feb 20, 2021
- Messages
- 358
- Location
- Rhea County TN
- Tractor
- AC 7600 TTR, Branson 5520CH, Grasshopper 928D2
I see. I have a bunch of nice torque wrenches but it may be nice just to "whiz" lugs on with an air gun.
Midniteoyl
Elite Member
- Joined
- May 20, 2013
- Messages
- 4,764
- Location
- N. W. Indiana
- Tractor
- Kioti CK3510SE HST, Ford 3400, Gizmow ZTR, Simplicity 7016H
I use a Makita impact w/auto stop that can be set anywhere from 'Stop at first 'impact' (~ 10ft/lbs) , to full on 'try to snap it off' (~450+ft/lbs). Usually run them up on the low setting, then again at the next higher when the tires are on the ground (~60lbs), then final torque by hand.
