Snowblower Hydraulic Chute Rotator

   / Snowblower Hydraulic Chute Rotator #11  
there'sa welded nut on the side of the chute the cable ties to.
 
   / Snowblower Hydraulic Chute Rotator #12  
Cheap and cheerful chute turner mod with minimal welding required. If you run past the cable limits you break the cable and get to fix it. I seem to manage this about once a season.

I replaced the hand crank with a short shaft and used a lovejoy coupler to take up any mis-alignment between the hydraulic motor and chute turner shaft. The motor was a spare I had kicking around, you don't need anything fancy or expensive. Slower speed motor is easier to control.

Here's a nice trick - I added UHMW tape I bought off amazon as a UHMW sliding surface to stop ice from binding in the chute rotator. Works better than lube sprays and has lasted 3 season so far.

I may try the UHMW tape on mine, although I'm not really experiencing and problems. Did your blower come with the plastic ring that the chute actually sits on? I suspect that would allow the chute to rotate much easier.
I went the lazy route when I added hydraulics to my LuckNow blower by buying the manufacturers kit. The cable is on a large half moon pulley driven by a standard cylinder. As much as I like my blower, it was a royal pain to get the parts from Canada.
 
   / Snowblower Hydraulic Chute Rotator #13  
I may try the UHMW tape on mine, although I'm not really experiencing and problems. Did your blower come with the plastic ring that the chute actually sits on? I suspect that would allow the chute to rotate much easier.
I went the lazy route when I added hydraulics to my LuckNow blower by buying the manufacturers kit. The cable is on a large half moon pulley driven by a standard cylinder. As much as I like my blower, it was a royal pain to get the parts from Canada.
The plastic ring is homebrew from an old HDPE/UHMW water jug.

I was finding the chute would ice up where I put the UHMW tape in certain weather conditions. The tape and plastic ring makes a nice bearing and no more icing or paint wear issues.

I've seen the half moon solution. I already had a motor and coupler on the shelf and replacing the hand crank was the simplist fabrication for me.
 
   / Snowblower Hydraulic Chute Rotator #14  
I got a good buy on a Meteor blower came with hydraulics but no rears on my Kubota. Ran it with a hand crank the first year. Picked up a cheap Harbor Freight winch under $50 built a mount and it works great. Works with cable and friction.
 
   / Snowblower Hydraulic Chute Rotator #15  
Anyone have a spec for the hydraulic motor you would use on one of these? I have rear remotes.
 
   / Snowblower Hydraulic Chute Rotator #16  
I used this kit on my Woods RM72 snow thrower:


It wasn't that much more than buying the motor and mount parts plus it includes the hyd. hoses and a chute deflector as well.
 

Tractor & Equipment Auctions

KOOMEY INC VALVE ACTUATOR (A55745)
KOOMEY INC VALVE...
2015 Kia Sorento AWD SUV (A55758)
2015 Kia Sorento...
2013 International TerraStar Enclosed Service Truck with Liftgate (A53422)
2013 International...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
Power Horse 7000 Generator (A54865)
Power Horse 7000...
REYNOLDS 100 - 8 YARD PULL TYPE SCRAPER PAN WITH DRAWBAR (A52748)
REYNOLDS 100 - 8...
 
Top