LS MT225S - Chainsaw scabbard

[brewdog]

Thanks. Was looking at some I had here and wondering how hard it would be to heat and reshape it..

If your wife lets you, toss it in the oven for 10 minutes at 300 degrees. It will be soft and pliable until is starts to cool off. Wear gloves and work fast. Good luck.

 

[dfkrug]

If your wife lets you, toss it in the oven for 10 minutes at 300 degrees. It will be soft and pliable until is starts to cool off. Wear gloves and work fast. Good luck.

That'll work. Plus, have a helper who can spray some water on the hot PVC as you hold it with gloves in the shape you want. Or a very wet rag.

 

[brewdog]

Remounted the quick-draw chainsaw scabbard on my ROPS. This is the best location for it yet.

 

[WranglerX]

If your wife lets you, toss it in the oven for 10 minutes at 300 degrees. It will be soft and pliable until is starts to cool off. Wear gloves and work fast. Good luck.

Go back and read post #4....

 

[brewdog]

Go back and read post #4....

Hi, Sure did. This post was for the first one I made that I removed. After using it I preferred to use the lager one with the blue frame in the same location. This one was made from PVC square tube and the blue framed one is made of HDPE.