Not sure if they are similar or not but on the old G1800 once you pressed the by pass button it stayed in untill you fired up the tractor and started using it.
Jack up the rear and block the front wheels. place the vehicle in 2wd and see if the rear wheels move without resistance when you press the go pedal. I had a BX that someone stomped on the diff lock when the wheels were spinning and it grenaded the rear differential. It would only move in 4wd...
I went with a Land Pride QH. They don't have the pin issues that other manufacturers have. The problem that I ran into was that all cat 1 implements are not the same. My solution was to make the equipment fit the hitch except for the Land Pride implements which fit their hitches. That with a...
The first thing you should do is remove the battery and take it to an auto parts store, they will load test it for free. A battery with a dead short will show 12 volts or more but will drop to zero when you apply a load. If the battery is good then at least you can eliminate the battery from...
I flew helicopters in the Army for 18 years and what they teach is that there is a critical angle and a rolling motion that causes rollovers. I always look in the user manuals to see what the critical angle is, no one ever has it listed. If the critical angle were published an an inclinometer...
I bought one for my BX2680. Growing up on a farm we had a woods quick hitch on our full size John Deere. prior to the QH05 I had a Harbor Freight QH on my BX2200. The QH05 is a lot better quality, lighter in weight and the top hook is fixed. The HFHQ allows you to change the position of the...
I would start by un coupling your hydraulic connection and make sure the ends are clean. Un fortunately you have to unhook the bucket and back up a little to be able to raise the hydraulic decoupling lever. I noticed with my 80 series that the more level the surface to drop the bucket the better.
I have a kubota BX 2680 that I purchased with 18 hours on it. I have added the BX2419 rear remote as well as a land pride QH05 quick hitch. Additionally I have installed a hydraulic top link. My problem lies with some clearance issues. When the three point at its highest point, without a 90...
I am not sure how they mount their seat. I found that when I placed my seat in the factory mount I felt like I was sliding off the seat. Also all together it raised the seat about 3 inches plus the seat was tilted forward. I found the lowest possible height I could based off the fuel tank and...
I bought the electrical version for my BX2680. My previous tractor BX1800 had a mechanical spring suspension seat and it was ok. The electrical air version is awesome. I also bought the lateral isolation assembly. I have 2 compressed vertebra in my back and 20 minutes on the tractor before...
I realize this is an older thread but thought I would weigh in on what I found. I added two additional fuses to my BX2680 factory fuse box. The box has three empty slots, no connectors, no power. I purchased several different types of connectors before I found one that would work like the...